6" Offset Steel Lower Arm Body Length:Up to 23ft 1" Flange mounted bearing to

1" Flange mounted bearing to replace SHURCO's 1119560

The HR1500HS uses your pre-existing hydraulic system and is powered by a right angle hydraulic direct-drive motor/gearbox combo

(1) Complete Premium Aluminum Arm Set (Either straight or bent)

hassle-free connectivity

and extreme weather conditions

6" Offset Steel Lower Arm Body Length:Up to 23ft 1" Flange mounted bearing to4 Spring or 5 Spring steel lower arm bent for a 6" offset for bodies with pivot pins mounted on the elliptical. Please call in ahead to inform us on the overall length of the arm you are needing. The length of the arm can vary from 93" overall to 36" overall. Typical 6" offset bends start 16" from the center point of the fork pivot point to the beginning of the first bend. From beginning of first bend to end of second bend is 8 1 2" finished.