14" x 108T Carbide Tipped Aluminum and Non-Ferrous Blade, Neg. 6 Deg., 1" Bore HT04-05 Panels powder coated in gray

Panels powder coated in gray

Looking to make a one-of-a-kind walking cane but haven’t found the right handle

load at the tip

Height increase: 3 inches

and finishing the signs

14" x 108T Carbide Tipped Aluminum and Non-Ferrous Blade, Neg. 6 Deg., 1" Bore HT04-05 Panels powder coated in grayThanks to its special carbide formulation and blade geometry, this is the ideal blade for cutting relatively thin walled aluminum and non ferrous extrusions and frames. The negative hook angle ( 6), triple chip grind and thick plate combine to produce a superior finish. The blade can also be used to cut other "difficult" materials such as plastic, PVC tubing, fiberglass and ACM (Aluminum Composite Material). Warning: Never attempt to cut ferrous